WRAS Approved Water Fittings (SEKISUI Aqua System Co,LTD)

WRAS Approved Water Fittings

Section: 0225
Cisterns
FIRE SPRINKLER SUCTION

Listing Number: 0310065

`Sekisui` insulated or uninsulated storage cistern with AB air gap` the sectional comprises a cold water cistern assembled from glass reinforced plastics (GRP) panels and polyester resin for construction of cold water storage cisterns for wholesome water. The panels are constructed in sandwich form with a layer of GRP each side of a 20mm thick block of insulation (ridge polyethylene foam). Manufacturers calculated thermal capacity of the insulated panels is 0.022098. The largest capacity cisterns have stainless steel internal bracing and PVC pole supports. The roof covers are of the same panel construction provided with manhole inspection hatch, joints are sealed with synthetic rubber gaskets. The weir dimensions is relevant to the inlet size. The dimensions of the weir is 1m x 0.5m and is acceptable for use with inlet dimensions up to DN 80. The storage cistern must be installed with a WRAS approved electrically operated level control switch and a WRAS approved electrically operated inlet valve.
Size: Maximum height 4m maximum capacity 2270000 litres.
Designation: Sekisui Insulation Tank with AB air gap. FS (1 metre high). FH & FHX (1.5 metre high). FW, FJX & FWX (2 metre high). FT & FTX (2.5 metre high). FZ & FZX (3 metre high). FK & FKX (3.5 metre high). FQ & FQX (4 metre high).
Marking: Data plate on side of cistern showing model number, size, capacity manufactured date, nominal capacity and manufactures name and address.
View Installation Requirements: R001 R270 R280 R350

Proviso:
Note:
Manufacturer: Sekisui Aqua Systems Co Ltd
Sekisui Aqua Systems Co Ltd
21st Floor, Tower West
Umeda Sky Bldg 1-30
1- Chome, Oyodo-Naka
Kita-Ku, Osaka 531-0076
Japan


Phone: +81 6440 2508
Fax: +81 6440 2518
Website: www.sps-int.com
List all fittings by this manufacturer
Factor:
List all fittings by this factor